Hi,
I would like to upload code on the DueUSB, using the Atmel JTAG-ICE. I have previously uploaded code using Atmel Visual Studio, so I know that there is no hardware problem. The upload on plaformio fails and i have played around with multiple configurations but still no luck, i have attached my current .ini file and the error message that I am currently receiving
The default upload address of 0x0 is wrong. You must configure it as
board_upload.offset_address = 0x80000
as discussed in
1 Like
Sorted just like that, thank you very much @maxgerhardt, from the posts I have been reading, you’re a wizard with this.
2 Likes