Upload error to Adafruit Huzzah esp8266

1

I get this error message uploading blinky test to Adafruit Huzzah ESP 8266, I can upload the same code via the Arduino IDE.

------------------------------- cut ----------------------------------------
Collected 13 compatible libraries
Looking for dependencies…
Project does not have dependencies
Looking for upload port…
Auto-detected: /dev/ttyUSB0
Uploading .pioenvs/featheresp32/firmware.bin
esptool.py v2.0-beta3

Connecting…
Uploading stub…

A fatal error occurred: Failed to enter RAM download mode. Only got 2 byte status response.
*** [upload] Error 2

------------------------------ cut -----------------------------------------

Thanks in advance,

Chris

2

Feather ESP32? Adafruit Huzzah esp8266 ? :open_mouth:

3

Ooops - apologies I should have spotted that myself.

Must try harder :slight_smile:

Thanks for the reply