In the current setup I do use the 5V from the probe to power the target board. I have just tried the other way, powering through the programming port without connecting 5V, did not help. The board itself is working in both setups, The LED on the probe is on, but cannot connect.
I have just tried to disconnect RESET, did not change.
Sometimes I get a popup to update the firmware. If I let it update, seems to update well, and the next time the popup does not appear.
Is this setting correct?:
Target connection timeout: 0 ms
Where can I increase it?
The “undefined” words disappeared. (It is a different PC).
This is the setup without 5V connected, board powered over USB programming port.
