Using PlatformIO in VSCode with an ESP-Prog connected to ESP32-CAM module. When I started working with this project, I could Upload to the ESP32-CAM without pulling the GPIO0 to GND, now I find I need to do that each time to upload my code. Is there a setting I can use to get around this? Sid

[image] sidprice: However, the “Monitor” command still places the target board into Reset with GPIO0 also low. The DTR/RTS line when the Monitor is open can be controlled with Redirecting... , see e.g. Noob stuck on ESP32-CAM+MB with PIO/vscode - #5 by maxgerhardt

PlatformIO Community

Problem uploading to ESP32-CAM with ESP-Prog

Development Platforms

maxgerhardt June 15, 2022, 10:18am 10

The DTR/RTS line when the Monitor is open can be controlled with Redirecting..., see e.g. Noob stuck on ESP32-CAM+MB with PIO/vscode - #5 by maxgerhardt

1 Like

ESP32 CAM Programmer Serial monitor