When I upload my firmware using JLink it runs successfully but it flashes it to address 0x00 instead of 0x08000000. If I look at the generated jlink script file (upload.jlink) I see: h loadbin .pioenvs/foo/firmware.bin,0x0 r This looks OK but I would expect the load address to be 0x08000000 not 0…

Resolved in Allow to configure upload offset address using `board_upload.offset_a… · platformio/platform-ststm32@853208d · GitHub You can override offset address in platformio.ini using board_upload.offset_addres option. Also, default address for ST STM32 was set to 0x08000000. Please re-test with…

PlatformIO Community

JLink uploading to incorrect address

Development Platforms

jeffstaley January 28, 2019, 1:08am 3

That should do it. Thanks.