Debugging Arduino Due with Black Magic Probe and VScode/W10

[Maxattax97]

Check this out to get up and running:

Unable to attach debugger to Arduino Due

After much toil we finally found a working configuration. We avoided uploading via the debugger altogether, and instead used another COM port with the sam-ba protocol instead. Whatever GDB commands PlatformIO thinks are right are no good either. [env:due] platform = atmelsam board = due board_build.mcu = at91sam3x8e board_build.f_cpu = 84000000L framework = arduino ; If any of your ports are 10 or over, use this format: \\.\COM10 debug_port = COM9 debug_tool = blackmagic upload_port = COM5 uplo…

I think that I’ve found there may be a firmware issue with the BMP for SAM3X8E chips, however I haven’t had time to spare toward debugging that effort. That is being tracking in this github issue. Error erasing flash with vFlashErase packet, Again... · Issue #414 · blackmagic-debug/blackmagic · GitHub